HP 158222-B21 - StorageWorks Fibre Channel SAN Switch 8 Installation Instructions Manual page 14

Figure 6: Assembling the outer rails (HP System/e rack)
5. Determine the number of #8-32 x 3/16-inch Phillips pan-head screws with
Table 1: Number of screws required to assemble the inner rails
SAN Switch 2/32
SAN Switch 2/16
SAN Switch 2/8
14
— For an HP System/e rack, install two #10-32 x 1/2-inch Phillips pan-head
screws with captive star lock washers and two #10 alignment washers in
the upper and lower hole locations of the right rail. Then install two
#10-32 x 1/2-inch Phillips pan-head screws with captive star lock washers
and two #10 alignment washers in the upper and lower hole locations of
the left rail. See
thread lock required to assemble the inner rails by referring to
Switch
Figure 6.
Number of #8-32 x 3/16-inch Screws
SAN Switch Rack Mount Kit Installation Instructions
12
10
14
Table 1.