HP 158222-B21 - StorageWorks Fibre Channel SAN Switch 8 Installation Instructions Manual page 11

Figure 3: Installing the rear mounting brackets (HP System/e rack-left rear upright)
Note:
and
SAN Switch Rack Mount Kit Installation Instructions
— For an HP System/e rack, install each of the two rear mounting brackets
with (2) #10-32 x 1/2-inch Phillips pan-head screws and (2) #10
alignment washers as shown in
This kit contains both left rails and right rails. The rails are marked with
Left
to distinguish the rails from each other.
Figure 3.
Right
11