Installing The Nvidia Raid Software Under Windows (For Non-Bootable Raid Array) - MSI Neo4 - K8N Platinum Motherboard User Manual

nVIDIA RAID Introduction
Installing the NVIDIA RAID Software Under Windows
(for Non-bootable RAID Array)
The existing Windows IDE Parallel ATA driver (as well as the Serial ATA driver if SATA
is enabled) must be upgraded to use the NVIDIA IDE Parallel ATA driver (as well as the
NV Serial ATA driver if SATA is enabled).
This section describes how to run the setup application and install the RAID software
which will upgrade the Windows IDE driver and install the RAID software.
1. Start the nForce Setup program to open the NVIDIA Windows nForce Drivers page.
2. Select the modules that you want to install. Make sure that the "NVIDIA IDE Driver"
is selected.
3. Click Next and then follow the instructions.
4. After the installation is completed, be sure to reboot the PC.
5. After the reboot, initialize the newly created array.
5-9