Table of Contents
Advertisement
2-5: SUB TINT/SUB COLOR
1.
Receive the color bar pattern.
2.
Connect the synchro scope to pin 1 of CP101 and the
pin 6 (GND) of CP101.
3.
Activate the adjustment mode display of Fig. 2-1 and
press the channel button (4) on the remote control.
The Fig. 2-4 appears on the display.
4.
Press the channel button (4) on the remote control.
5.
Press the VOL. UP/DOWN button on the remote control
until the waveform becomes as shown in Fig. 2-5.
6.
Press the CH DOWN button once to set to "COLOR"
mode.
7.
Adjust the LEVEL "A" section of Blue to the LEVEL "D"
section of White by pressing the VOL. UP/DOWN button
on the remote control. (Refer to Fig. 2-6)
8.
If the LEVEL "A" section through "C" section are not the
same compared with "D" section, adjust the LEVEL again.
"D"
2-6: FOCUS
1.
Receive an 80dB monoscope pattern.
2.
Adjust the Focus Volume until picture is distinct.
2-7: VERTICAL POSITION
1.
Receive the color bar pattern.
2.
Using the remote control, set the brightness and
contrast to normal position.
3.
Adjust the VR401 until the horizontal line of the color
bar comes to approximate center of the CRT.
ELECTRICAL ADJUSTMENTS
"C"
"B"
"A"
2-8: VERTICAL SIZE
1.
Receive the crosshatch pattern.
2.
Using the remote control, set the brightness and
contrast to normal position.
3.
Activate the adjustment mode display of Fig. 2-1 and
press the channel button (1) on the remote control.
The Fig. 2-7 appears on the display.
4.
Press the channel button (3) on the remote control.
5.
Press the VOL. UP/DOWN button on the remote control
until the center of crosshatch is square.
2-9: HORIZONTAL PHASE
1.
Receive the color bar pattern.
2.
Using the remote control, set the brightness and
contrast to normal position.
3.
Activate the adjustment mode display of Fig. 2-1 and
press the channel button (1) on the remote control.
Fig. 2-5
The Fig. 2-7 appears on the display.
4.
Press the channel button (1) on the remote control.
5.
Press the VOL. UP/DOWN button on the remote control
until the SHIFT quantity of the OVER SCAN on right
and left becomes minimum.
2-10: OSD HORIZONTAL
1.
Using the remote control, set the brightness and
contrast to normal position.
2.
Activate the adjustment mode display of Fig. 2-1 and
press the channel button (5) on the remote control.
The Fig. 2-2 appears on the display.
3.
Press the channel button (4) on the remote control.
Fig. 2-6
4.
Press the VOL. UP/DOWN button on the remote control
until the difference of A and B becomes minimum.
D1-2
1. H. PHASE
2. H. BLK
3. V. SIZE
4. V. POSI
5. V. LIN
6. V. SC
7. V. COMP
8. (H FREQ)
0. RETURN
OSD H
A
Fig. 2-7
[ TV ]
B
Fig. 2-8
Advertisement
Table of Contents
