Installing And Uninstalling Novell Sentinel Log Manager; System Prerequisites - Novell SENTINEL LOG MANAGER 1.0.0.5 - INSTALLATION GUIDE 03-31-2010 Installation Manual

Installing and Uninstalling Novell
3
Sentinel Log Manager
This section describes how to install and uninstall Novell
Managers. It also describes configuration settings for remote storage servers. These instructions
assume that the minimum requirements for each system component are met. For more information
on system requirements, see
The Sentinel Log Manager installation package installs the following components:
Sentinel Log Manager server
Communications server
Web server and Web-based user interface
Reporting server
Collector Manager
Some of these components require additional configuration.
Section 3.1, "System Prerequisites," on page 27
Section 3.2, "Installing on an Existing Operating System," on page 28
Section 3.3, "Logging in to Novell Sentinel Log Manager," on page 30
Section 3.4, "Configuring Archive Server Settings," on page 30
Section 3.5, "Installing Additional Collector Managers," on page 33
Section 3.6, "Post-Installation Configurations," on page 37
Section 3.7, "Uninstalling Novell Sentinel Log Manager," on page 37

3.1 System Prerequisites

The preliminary settings listed in this section are needed to run Sentinel Log Manager.
Sentinel Log Manager should always be installed on a certified operating system. For more
information on supported operating systems, see the
page 19. All system testing was performed using the ext3 file system.
Install the following operating system commands:
mount
umount
id
df
du
sudo
Root credentials are needed for some steps in the Sentinel Log Manager installation.
Chapter 2, "System Requirements," on page
Chapter 2, "System Requirements," on

Installing and Uninstalling Novell Sentinel Log Manager

®
Sentinel Log Manager and Collector
TM
19.
3
27