Creating A New Driver; Creating The Driver In Designer; Importing The Driver Configuration File; Chapter 3, "Creating A New Driver - Novell IDENTITY MANAGER 3.6.1 - MANUAL TASK SERVICE DRIVER Implementation Manual

Creating a New Driver

3
After the Manual Task Service driver files are installed on the server where you want to run the
driver (see Chapter 2, "Installing Driver Files," on page
Vault. You do so by importing the basic driver configuration file and then modifying the driver
configuration to suit your environment.
The driver provides four basic driver configuration files:
Access Request
Cellphone Request
Room Number Request
Welcome E-mail
The configuration files include the filters and policies needed to implement each scenario. If you
have a different scenario you want to implement, you should select the basic configuration that most
closely resembles your desired scenario and modify it as needed.
The following sections provide instructions for creating a new driver:
Section 3.1, "Creating the Driver in Designer," on page 21
Section 3.2, "Creating the Driver in iManager," on page 23
Section 3.3, "Activating the Driver," on page 26

3.1 Creating the Driver in Designer

You create the Manual Task Service driver by importing the driver's basic configuration file and
then modifying the configuration to suit your environment. After you create and configure the
driver, you need to deploy it to the Identity Vault and start it.
Section 3.1.1, "Importing the Driver Configuration File," on page 21
Section 3.1.2, "Configuring the Driver," on page 22
Section 3.1.3, "Deploying the Driver," on page 22
Section 3.1.4, "Starting the Driver," on page 23

3.1.1 Importing the Driver Configuration File

1 In Designer, open your project.
2 In the Modeler, right-click the driver set where you want to create the driver, then select New >
Driver to display the Driver Configuration Wizard.
3 In the Driver Configuration list, select the desired Manual Task Driver configuration file
(Access Request, Cellphone Request, Room Number Request, or Welcome Email), then click
Run.
The configuration files include the filters and policies needed to implement each scenario. If
you have a different scenario you want to implement, you should select the basic configuration
that most closely resembles your desired scenario and modify it as needed.
19), you can create the driver in the Identity
3
Creating a New Driver 21