Creating A New Driver; Creating The Workorder Container In The Identity Vault; Creating The Driver In Designer; Importing The Driver Configuration File - Novell IDENTITY MANAGER 3.6.1 - WORKORDER DRIVER IMPLEMENTATION GUIDE 18-12-2009 Implementation Manual

Creating a New Driver

4
After the WorkOrder driver files are installed on the server where you want to run the driver (see
Chapter 3, "Installing Driver Files," on page
do so by importing the basic driver configuration file and then modifying the driver configuration to
suit your environment. The following sections provide instructions:
Section 4.1, "Creating the WorkOrder Container in the Identity Vault," on page 19
Section 4.2, "Creating the Driver in Designer," on page 19
Section 4.3, "Creating the Driver in iManager," on page 22
Section 4.4, "Activating the Driver," on page 25
4.1 Creating the WorkOrder Container in the
Identity Vault
The WorkOrder driver requires you to specify an Identity Vault container for WorkOrder objects and
WorkToDo objects. You can use an existing container for these objects, but we strongly recommend
that you create a new container. You can give the container any name you want (for example,
WorkOrders). You should restrict rights to the container so that only authorized administrators can
change the container or the objects it holds.

4.2 Creating the Driver in Designer

You create the WorkOrder driver by importing the driver's basic configuration file and then
modifying the configuration to suit your environment. After you've created and configured the
driver, you need to deploy it to the Identity Vault and start it.
Section 4.2.1, "Importing the Driver Configuration File," on page 19
Section 4.2.2, "Configuring the Driver Settings," on page 20
Section 4.2.3, "Deploying the Driver," on page 21
Section 4.2.4, "Starting the Driver," on page 21

4.2.1 Importing the Driver Configuration File

1 In Designer, open your project.
2 In the Modeler, right-click the driver set where you want to create the driver, then select New >
Driver to display the Driver Configuration Wizard.
3 In the Driver Configuration list, select WorkOrder, then click Run.
4 On the Import Information Requested page, fill in the following fields:
Driver Name: Specify a name that is unique within the driver set.
WorkOrder Container: Browse for and select the container you've created for WorkOrder
objects (see Section 4.1, "Creating the WorkOrder Container in the Identity Vault," on
page 19).
17), you can create the driver in the Identity Vault. You
4
Creating a New Driver 19