Table of Contents
Advertisement
BIOS:
OS:
CAUTION!
1.
To support FSB1066, please use DDR400 DIMMs (Double Data Rate 400
MHz). Before installing FSB1066 CPU, please make sure that you have
adjusted the jumpers correctly. The default setting of FSB1 is shorting
pin1 and pin2. However, if you want to support FSB1066 CPU, please
adjust your FSB1 jumper setting, and short pin2 and pin3 (see page 17).
2.
About the setting of "Hyper Threading Technology", please check page 25.
3.
Please check the table below for the memory support frequency and its
corresponding CPU FSB frequency.
CPU FSB Frequency
*
When you use an FSB800-CPU on this motherboard, it will run at
DDR320 if you adopt a DDR333 memory module.
4.
This motherboard supports Dual Channel Memory Technology. Before you
implement Dual Channel Memory Technology, make sure to read the
installation guide of memory modules on page 14 for proper installation.
5.
While CPU overheat is detected, the system will automatically shutdown.
Before you resume the system, please check if the CPU fan on the
motherboard functions properly and unplug the power cord, then plug it
back again. To improve heat dissipation, remember to spray thermal
grease between the CPU and the heatsink when you install the PC system.
6.
Do NOT use a 3.3V AGP card on the AGP slot of this motherboard!
It may cause permanent damage!
7.
Power Management for USB 2.0 works fine under Microsoft
SP1 / 2000 SP4. It may not work properly under Microsoft
ME.
8.
For microphone input, this motherboard supports both stereo and mono
modes. For audio output, this motherboard supports 2-channel, 4-channel,
6-channel, and 8-channel modes. Please check the table on page 9 for
proper connection.
9.
Although this motherboard offers stepless control, it is not recommended
to perform over-clocking. Frequencies other than the recommended CPU
bus frequencies may cause the instability of the system or damage the
CPU.
Audio Jack: Side Speaker / Rear Speaker / Central/Bass /
Line In / Front Speaker / Microphone
(see CAUTION 8)
AMI legal BIOS,
Supports "Plug and Play",
ACPI 1.1 compliance wake up events,
Supports jumperfree,
CPU frequency stepless control
(only for advanced users' reference, see CAUTION 9)
®
Microsoft
Windows
Memory Support Frequency
1066
800
533
®
98 SE / ME / 2000 / XP compliant
DDR400*
*
DDR266, DDR320
, DDR400
DDR266, DDR333
®
®
Windows
XP
®
Windows
®
98/
Advertisement
Table of Contents
