NETGEAR DGN2200v3 Installation Manual page 13

If the modem router does not power on:
1. Check your cables.
• Disconnect and reconnect each cable. There is usually an
audible click when the cable is correctly connected.
• See if the telephone cable connecting your DSL modem
router to the wall jack is plugged into a filter. A filter is not
required if you do not have telephone voice service. A filter
installed where it is not needed might eliminate your ADSL
signal.
2. Power down your DSL modem router, and then power it up again.
a. Shut down your computer and turn off the modem router.
b. Unplug the power adapter and all other cables from the back
of the DSL modem router.
c. Wait 30 seconds, then reconnect the cables and adapter to
your DSL modem router, and turn it on.
d. Make sure that the router power light is on. If the light is off,
try plugging the adapter into another power outlet.
e. Turn your computer back on, and wait for the indicator lights
to turn green.
3. Open a web browser and try to access the Internet.
If steps 1-3 do not resolve the problem:
4. Reset your modem.
To reset your DSL modem router, use a pin or paper clip to press
in and hold the Reset button.
11