Maintenance - iRobot ROOMBA Owner's Manual

Maintenance

To keep Roomba running at peak performance, it is recommended that you
perform the following maintenance tasks every three uses:
Remove and empty
1
Roomba's bin
Press button and
pull to remove bin
Clean Roomba's filter
2
compartment
a. Clean or replace filter*
B. Clean filter
compartment
*Replace filter every 2 months
TIP: Bin emptying and brush cleaning should be done after every 3- cleaning
cycles depending on the amount of hair, dirt, and debris in your environment.
TIP: If you notice roomba picking up less debris from your floor, empty the bin
and clean the brushes.
excessive build up of hair in roomba's brushes and bearings can
permanently damage roomba. Inspect brush bearings regularly.
Do not attempt to run roomba without the bearings. If you misplace
roomba's brush bearings, contact Customer service for replacement
bearings.
Empty bin
Visit www.irobot.com/usetips for instructional photos
www.domotec.uk.com • www.irobot.com
Clean Roomba's brushes
3
a. Remove brush guard by pulling
both yellow tabs
B. Remove brush caps and use scissors
to cut any hair wrapped around the
brush. Use the Roomba cleaning tool
to comb hair from brush.
Brush
caps
C. Remove and clean hair and dirt from
Roomba's brush bearings. You MUST
refit bearings and brush caps before
reuse.
Brushes
Brush
caps
Brush
bearings
21