Table of Contents
Advertisement
2-3-2 About INTEL PENTIUM 4 478-PIN CPU
This motherboard provides a 478-pin surface mount, Zero Insertion Force (ZIF) socket, referred
to as the mPGA478B socket supports Intel Pentium 4 processor in the 478 Pin package utilizes
Flip-Chip Pin Grid Array (FC-PGA2) package technology.
The CPU that comes with the motherboard should have a cooling FAN attached to prevent
overheating. If this is not the case, then purchase a correct cooling FAN before you turn on your
system.
WARNING!
Be sure that there is sufficient air circulation across the processor's heatsink
and CPU cooling FAN is working correctly, otherwise it may cause the
processor and motherboard overheat and damage, you may install an auxiliary
cooling FAN, if necessary.
To install a CPU, first turn off your system and remove its cover. To locate the ZIF socket and
open it by first pulling the level sideways away from the socket then upward to 90-degree. Insert
the CPU with the correct orientation as shown below. The notched corner should point toward
the end of the level. Because the CPU has a corner pin for two of the four corners, the CPU will
only fit in the orientation as shown.
When you put the CPU into the ZIF socket. No force needed to insert of the CPU, then press the
level to Locate position slightly without any extra force.
2-4 To install the system memory
This motherboard provides three 184-pin DUAL INLINE MEMORY MODULES (DIMM) sites
for memory expansion available from minimum memory size of 64MB to maximum memory size
of 3.0GB DDR SDRAM.
Valid Memory Configurations
Bank
Bank 0, 1 (DDR1)
Bank 2, 3 (DDR2)
Bank 4, 5 (DDR3)
Total
NOTE! Make sure the total installed memory does not exceed 3.0GB, otherwise the system
may hang during startup.
CPU ZIF mPGAB Socket
184-Pin DIMM
PC2100/PC2700/PC3200 DDR SDRAM
PC2100/PC2700/PC3200 DDR SDRAM
PC2100/PC2700/PC3200 DDR SDRAM
System Memory (Max. 3.0GB)
Colden Arrow
PCS
X1
X1
X1
3
9
Total Memory
64MB∼1.0GB
64MB∼1.0GB
64MB∼1.0GB
64MB∼3.0GB
Advertisement
Table of Contents
