Chapter 2 Hardware Installation; Hardware Installation Steps; Checking Motherboard's Jumper Setting - JETWAY P4XFAR5A User Manual

CNR
Hardware installation

2-1 Hardware installation Steps

Before using your computer, you had better complete the following steps:
1. Check motherboard jumper setting
2. Install CPU and Fan
3. Install System Memory (DIMM)
4. Install Expansion cards
5. Connect IDE and Floppy cables, Front Panel /Back Panel cable
6. Connect ATX Power cable
7. Power-On and Load Standard Default
8. Reboot
9. Install Operating System
10. Install Driver and Utility

2-2 Checking Motherboard's Jumper Setting

(1) CMOS RAM Clear (3-pin) : JBAT
A battery must be used to retain the motherboard configuration in CMOS RAM short
1-2 pins of JBAT to store the CMOS data.
To clear the CMOS, follow the procedure below:
1. Turn off the system and unplug the AC power
2. Remove ATX power cable from ATX power connector
3. Locate JBAT and short pins 2-3 for a few seconds
4. Return JBAT to its normal setting by shorting pins 1-2
5. Connect ATX power cable back to ATX power connector
Note: When should clear CMOS
1. Troubleshooting
2. Forget password
3. After over clocking system boot fail
(2) Keyboard Power On function Enabled/Disabled: JP1
CNR Slot
Chapter 2
JBAT
1-2 closed Normal
Communication Network Riser Slot
JBAT
1 3
2-3 closed Clear CMOS
CMOS RAM Clear Setting
7
1 3