Connectors - JETWAY P4X400DMR2A User Manual

2-6-1 Connectors

(1) Power Connector (20-pin block) : ATXPWR
ATX Power Supply connector. This is a new defined 20-pins connector that usually
comes with ATX case. The ATX Power Supply allows to use soft power on momentary
switch that connect from the front panel switch to 2-pins Power On jumper pole on the
motherboard. When the power switch on the back of the ATX power supply turned on,
the full power will not come into the system board until the front panel switch is
momentarily pressed. Press this switch again will turn off the power to the system
board.
(2) ATX 12V Power Connector (4-pin block) : ATX12V
This is a new defined 4-pins connector that usually comes with ATX Power Supply. The
ATX Power Supply which fully support Pentium 4 processor must including this
connector for support extra 12V voltage to maintain system power consumption.
Without this connector might cause system unstable because the power supply can not
provide sufficient current for system.
(3) PS/2 Mouse & PS/2 Keyboard Connector: PS2KBM
The connectors for PS/2 keyboard and PS/2 Mouse.
(4) USB Port connector: USB/USB1
The connectors are 4-pin connector that connect USB devices to the system board.
(5) LAN Port connector: LAN (only for P4X400DMP)
This connector is standard RJ45 connector for Network
(6) Parallel Port Connector (25-pin female): PARALL
Pin 1
PIN ROW2
1 3.3V
2 -12V
3 GND
4 Soft Power On
5 GND
6 GND
7 GND
8 -5V
9 +5V
10 +5V
Pin 1
12
ROW1
3.3V
3.3V
GND
5V
GND
5V
GND
Power OK
+5V (for Soft Logic)
+12V