Install Memory - JETWAY P400BTR2A User Manual

When you put the CPU into the ZIF socket. No force require to insert of the CPU, then press
the level to Locate position slightly without any extra force.

2-4 Install Memory

This motherboard provides
(DIMM) sites for DDR memory expansion available from minimum memory size of 64MB to
maximum memory size of 3.0GB DDR SDRAM.
Valid Memory Configurations
Bank
Bank 0, 1 (DDR1)
Bank 2, 3 (DDR2)
Bank 4, 5 (DDR3)
Total
Generally, installing DDR SDRAM modules to your motherboard is very easy, you can refer
to figure 2-4 to see what a 184-pin DDR SDRAM module looks like.
NOTE! When you install DIMM module fully into the DIMM socket the eject tab
should be locked into the DIMM module very firmly and fit into its
indention on both sides.
WARNING! For the DDR SDRAM CLOCK is set at 133MHz, use only DDR266- compliant
DDR Modules. When this motherboard operate at 133MHz, most system will
not even boot if non-compliant modules are used because of the strict
timing issues, if your DDR Modules are not DDR266-compliant, set the
SDRAM clock to 100MHz to ensure system stability.
CPU ZIF mPGAB Socket
three 184-pin DDR DUAL INLINE MEMORY MODULES
184-pin DDR DIMM
DDR333/266/200 DDR DRAM Module
DDR333/266/200 DDR DRAM Module
DDR333/266/200 DDR DRAM Module
System Memory (Max. 3.0GB)
Colden Arrow
10
PCS Total Memory
X1 64MB∼1.0GB
X1 64MB∼1.0GB
X1 64MB∼1.0GB
X3 64MB∼3.0GB
Figure 2-4