Table of Contents
Advertisement
(3)
USB Port connector: USB2
(4)
USB Port connector: UL1 (USB)
The connectors are 4-pin connector that connect USB devices to the system board.
(5)
LAN Port connector: LAN
This connector is standard RJ45 connector for Network connector.
(6)
PS/2 Mouse & PS/2 Keyboard Connector: KB (PS2 KB/MOUSE)
The connectors for PS/2 keyboard and PS/2 Mouse.
(7)
Audio Line-In, Lin-Out, MIC Connector : CN1
This Connector are 3 phone Jack for LINE-OUT, LINE-IN, MIC
Line-out :
Line-in :
MIC :
(8)
VGA Connector (15-pin D-Sub) Connector: VGA (for 915GDAP/915GDA only)
VGA is the 15-pin D-Subminiature female connector for display monitor.
(9)
Serial Port COM1: COM1 (COM1 only for 915PDAP/915PDA)
COM1 is the 9-pin D-Subminiature mail connector. The On-board serial port can be
disabled through BIOS SETUP. Please refer to Chapter 3 "INTEGRATED
PERIPHERALS SETUP" section for more detail information.
(10) Floppy drive Connector (34-pin block): FDD
This connector supports the provided floppy drive ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to the floppy drives.
Audio output to speaker (Front Speaker)
Audio input to sound chip (Rear Surround Speaker)
Microphone Connector
PS/2
Keyboard
Pin 1
PS/2
Mouse
VGA/COM1 USB2 USB
FDD
Floppy Drive Connector
13
LAN
MIC
Line-IN/
Rear Surround
Line-Out/Front
Advertisement
Table of Contents
