Table of Contents
Advertisement
This motherboard provides an AGP Slot, support the 1X/2X/4X AGP VGA card.
2-6 Connectors, Headers
2-6-1 Connectors
(1)
Power Connector (20-pin block) : ATXPOWER
ATX Power Supply connector. This is a new defined 20-pins connector that usually
comes with ATX case. The ATX Power Supply allows to use soft power on momentary
switch that connect from the front panel switch to 2-pins Power On jumper pole on the
motherboard. When the power switch on the back of the ATX power supply turned on,
the full power will not come into the system board until the front panel switch is
momentarily pressed. Press this switch again will turn off the power to the system
board.
(2)
PS/2 Mouse & PS/2 Keyboard Connector: J2
The connectors for PS/2 keyboard and PS/2 Mouse.
(3)
USB Port connector: J3
The connectors are 4-pin connector that connect USB devices to the system board.
(4)
Parallel Port Connector (25-pin female): PARALLEL
Parallel Port connector is a 25-pin D-Subminiature Receptacle connector. The On-
board Parallel Port can be disabled through the BIOS SETUP. Please refer to Chapter 3
"INTEGRATED PERIPHERALS SETUP" section for more detail information.
Audio and Game Connector : AUD _ GAME
(5)
This Connector are 3 phone Jack for LINE-OUT, LINE-IN, MIC and a 15-pin
AG P SLO T
PIN
ROW2
1
3.3V
2
-12V
3
GND
4
Soft Power On
5
GND
6
GND
7
GND
8
-5V
9
+5V
10
+5V
Pin 1
13
ROW1
3.3V
3.3V
GND
5V
GND
5V
GND
Power OK
+5V (for Soft Logic)
+12V
Advertisement
Table of Contents
