Hot Water Supply - Asko 1325 Installation Instructions Manual

CORNER INST CORNER INST CORNER INST CORNER INST CORNER INSTALLA ALLA ALLA ALLATION ALLA
If the dishwasher is installed in a corner, there must be
a minimum clearance of 2 inches (50 mm) from the
side wall so the door can open.
HOT T T T T W W W W W A A A A A TER SUPPL HO HO TER SUPPL TER SUPPL TER SUPPLY Y Y Y Y
HO HO TER SUPPL
WARNING! Plumbing connections must comply with
applicable sanitary, safety and plumbing codes in your
area.
The machine should preferably be connected to a hot
water supply. If a cold water supply is used, the washing
times will be longer but the performance will not be
affected.
The hot water supply line should be minimum 3/8" OD
copper tubing. The inlet valve has a 3/8" NPT female
connection.
CONNECTIONS CONNECTIONS
CONNECTIONS CONNECTIONS CONNECTIONS
Compression nut
Inlet valve, 3/8" OD
90° street elbow
Page 4
TION TION TION TION
Compression sleeve
3/8" OD copper
water line
90° compression elbow
3/8" NPT one end
2" clearance
After determining where the water supply line will enter
the dishwasher, drill a 1" access hole and run the line
to the approximate inlet valve location shown in the figure
below. The inlet valve is on the right front of the machine,
so the water line should be placed on the right side.
If you use soft copper line, leave the tube straight out in
the opening to slide the dishwasher in. Bend the tube
into position after the dishwasher is slid into the cabinet
opening.
For service convenience, a shut-off valve (not supplied)
should be installed in the supply line in an easily
accessible location (such as, beneath the sink) or in
the supply line near the dishwasher fill valve.
It is important that the water supply line and the shut-off
valve have a sufficient flow volume. At last 3 gallons (12
liters) per minute must be able to pass through the
line. The water pressure should be 18-176 psi.
WARNING!
In order to prevent heat damage to the inlet valve, all
solder connections must be made before the water
line is connected to the dishwasher.
INST INST INSTALLA INST INST ALLATION ALLA ALLA ALLA

(1) Hot water supply

(2) Shut-off valve
(not supplied)
NOTE: You should only install the number 4 tubing
before you push the machine into position.
Tubing number 5 is to be fitted when the
machine is in position.
TION TION TION TION
(3) Alternate locations
(4) & (5) Tubing