Compiler Messages; Compiler Warnings; (W) Cannot Assign Unlike Types; (W) Define_Call Is Not Used - AMX NETLINX PROGRAMMING LANGUAGE Manual

Compiler Messages

Compiler Warnings

Sometimes the compiler generates a warning message instead of an error message; these warning
messages always start with w. A warning about a particular statement means that the statement is not
technically an error, but you should be careful doing it. Warnings, unlike errors, do not stop the program
from compiling.

(w) Cannot assign unlike types

This warning occurs when a variable or value of one type is assigned to a variable of a different type.
Here are some examples:
This message is a warning and not an error, because X = ITOA(12) works correctly when X is a simple
variable, since the result is a single value between Ø and 65,535.

(w) Define_Call is not used

This warning occurs at the end of program compilation for each DEFINE_CALL subroutine that was
declared but never used.

(w) Integer applies to arrays only

This warning appears when the keyword INTEGER is applied to a non-array type of variable.
Doing this is not an error, because non-array variables are already integers, but it is redundant.

(w) Long_While within While

This warning occurs if the compiler finds a LONG_WHILE or MEDIUM_WHILE inside a block of
code following a WHILE keyword.
This warning exists because the WHILE command has a 1/2 second timeout period, and the
LONG_WHILE and MEDIUM_WHILE keywords do not. This could create a hard-to-find logic error.
The solution is to change the WHILE to a LONG_WHILE.

(w) Possibly too many nested levels

This warning appears if there is a large amount of nesting in the program. This can happen with a long
chain of IF...ELSE IF statements.
The solution is to use the SELECT...ACTIVE set of statements.
NetLinx Programming Language Reference Guide
Assigning a string literal, string expression, or array to a non-array variable
Assigning a non-array variable to an entire array
Assigning an integer array to a non-integer array
Assigning a two-dimensional array to a one-dimensional array, or vice versa
Assigning the result of a function that returns an array type to a non-array variable or to a two-
dimensional array variable (for example, X = ITOA(12), where X is a non-array variable or
two-dimensional array variable)
Assigning the result of a function that returns a non-array type to a one- or two-dimensional
array variable (for example, X = ATOI('AMX'), where X is a one- or two-dimensional array
variable)
Compiler Messages
167