AMX I!-PCLINK WEB Instruction Manual page 16

Running i!-PCLink/Web
d. Auto Mode Connect
FIG. 10 Auto Mode Connect
Please enter the system number of the NetLinx system you wish to connect to. This connection
mode will attempt to connect to the first available NetLinx system with the specified system
number.
3. The NetLinx device field is to identify the i!-PCLink/Web software to the NetLinx master.
(Default = 8001). Please see Device Section
4. If the Auto Connect to NetLinx option is checked, the program will attempt to auto connect to
NetLinx with the current connection settings for the following events.
If the connection is manually disconnected, Auto Connect will be suspended; you will have to
manually re-connect. Connecting manually will re-enable the Auto Connect functionality.
If the authentication requirement is enabled on the NetLinx master, you need to set i!-PCLink/Web
to look for and use authentication. If you do not provide authentication to a security enabled master
the connection will fail. To set the authentication:
5. Place a check next to Authentication Required. This enables the username password fields.
10
On the initial load of the program.
If the NetLinx connection is lost.
i!-PCLinkWeb