Presets For Receiver Am/Fm Tuner Dialog; Adding A Preset To The List; Editing The Display Name For An Existing Preset - AMX DESIGN XPRESS HOME THEATER V1.3 - PROGRAMMER GUIDE Instruction Manual

Presets for Receiver AM/FM Tuner dialog

The Presets for Receiver AM/FM Tuner dialog sets up the radio presets for the receiver's AM/FM
tuner. You can setup and define as many presets as are present on the AM/FM tuner.
The presets must be discrete and must be on the same bank of presets. If you tuner has 3 sets of
presets (for example FM1, FM2, AM), and each set has 10 presets for a total of 30 presets, DXP-HT
would only be able to recall 10 presets. If your tuner uses Preset Up and Preset Down buttons,
DXP-HT would not be able to recall any presets using the AM/FM preset page.
FIG. 18 Presets for Receiver AM/FM Tuner dialog

Adding a Preset to the list

1. Enter a name for the Preset in the Display Name text field. Then assign a unique Preset
Number.
2. If the selected Tuner is IR-controlled (as specified in the Device Data tab of the Device
Configuration dialog), use the Preset Commands combo boxes to select up to three
commands per preset, to allow for different methods of recalling presets.
3. Click the Add button to add the new Preset to the bottom of the list.
4. Select a Preset in the list and click the Insert button to insert the new Preset in the row above
the selection.

Editing the Display Name for an Existing Preset

1. Select one from the list, and enter the new name in the Display Name text field. Click Apply to
apply the change.
2. Use the up/down arrow buttons to change the order in which the Preset buttons will occur on
the touch panel.
DXP-HT v1.3 - Programmer's Guide
Using the DXP-HT Project Wizard
51