Setting Program Preferences - AMX DESIGN XPRESS HOME THEATER V1.3 - PROGRAMMER GUIDE Instruction Manual

This dialog is also used by the Design XPress application to fill-in some data within
the project. This means that if you do an initial installation of DXP-HT you will be
asked to enter your information into the User Information dialog. Once this data has
been entered, you will not be asked for it again. Consecutive launches of the
application display the User Information dialog already populated with the pre-
entered data.
If the application is at some point un-installed and then re-installed, you will be
prompted to re-enter you information. If the No longer show on startup selection
has been chosen/enabled, you will no longer be asked to enter any user data into the
User Information dialog.

Setting Program Preferences

Select Edit > Preferences to open the Preferences dialog (FIG. 3), where you can set various user
preferences for DXP-HT.
FIG. 3 Preferences dialog
The options in this dialog include:
DXP-HT v1.3 - Programmer's Guide
Show Splash Screen on Startup: A toggling option to show the DXP-HT splash screen
when the program is started. If this item is not checked the splash screen can be viewed
by selecting Help > About.
Warn On Duplicate Channel Preset Names and Channels: Alerts you to the creation
of duplicate channel preset names and channels. All Channel Preset names and channels
must be unique.
Warn On Duplicate Tuner Preset Names and Channels: Alerts you to the creation of
duplicate tuner preset names and channels. All Tuner Preset names and channels must be
unique.
Introduction
15