Identify Panel Components; Connecting The Panel To Earth Ground - GE 60-806-95R-16Z - Security Concord Express System Control Panel Installation Instructions Manual

7
8. Install the antenna housing (included with the panel) by pushing it down into the top left hole
of the cabinet until it snaps into place (see Figure 3).
9. Install the circuit board into the cabinet, inserting the loop antenna loop up into the antenna
housing (see Figure 3), then secure the circuit board with the four mounting screws
(included).
Antenna Housing
Figure 3. Installing the Antenna Housing and the Circuit Board

Identify Panel Components

Before installing devices and making wiring connections, familiarize yourself with the main
components of the panel. Figure 4 shows the main component locations on the circuit board.
Antenna Loop
Backup
Battery
Connections
Red
Programming
Touchpad
Header
Terminal Strip
SnapCard
Header
Figure 4. Main Component Locations

Connecting the Panel to Earth Ground

For maximum protection from lightning strikes and transients, connect the lower-right circuit
board screw to earth ground as shown in Figure . Use 16-gauge, solid copper wire from an earth
grounded cold water pipe clamp to the panel.
Micro
Processor
EEPROM
Insert Antenna Loop
Up Into Antenna Housing
Installing the System