D-Link xStack DGS-3426 User Manual page 153

xStack DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
The Router Ports Settings window displays all of the current entries to the Switch's static router port table. To modify an entry,
click the Modify button. This will open the Router Port window, as shown below.
The following parameters can be set:
Parameter Description
Unit Select the switch in the switch stack to be modified.
VID (VLAN ID) This is the VLAN ID that, along with the VLAN Name, identifies the VLAN where the multicast
router is attached.
This is the name of the VLAN where the multicast router is attached.
VLAN Name
Member Ports Ports on the Switch that will have a multicast router attached to them. There are three options
for which to configure these ports:
None – Click this option to not set these ports as router ports
Static – Click this option to designate a range of ports as being connected to a multicast-
enabled router. This command will ensure that all packets with this router as its destination will
reach the multicast-enabled router.
Forbidden – Click this option to designate a port or range of ports as being forbidden from
being connected to multicast enabled routers. This ensures that these configured forbidden
Figure 7- 23. Router Port Settings window
Figure 7- 24. Router Port window - Modify
139