Starting Warm Engine; Stopping Engine - Echo SRM-260 - 11-03 Operator's Manual

16

STARTING WARM ENGINE

The starting procedure is the same as Cold Start except DO NOT close
the choke, and do not hold throttle trigger fully depressed.
WARNING
When engine starts, the cutting attachment may move even with
the throttle trigger in idle (released) position.
1. Stop Switch
Move stop switch button (A) forward away from the STOP
position.
2. Primer
Pump primer bulb (C) until fuel is visible in the "Clear" fuel return
line.
3. Start
Lay the unit on a flat, clear area and pull the recoil starter handle
(D) until the engine fires.
NOTE
If engine does not start after 5 pulls, use Cold Start Procedure.

STOPPING ENGINE

1. Release Throttle.
Allow engine to return to idle before shutting off engine.
2. Stop Switch
Move stop switch button (A) backward to STOP position.
WARNING
If engine does not stop when stop switch is moved to STOP
position, close choke - COLD START position - to stall engine.
Have your ECHO dealer repair stop switch before using trimmer
again.
DANGER
DANGER
A
C
A