Industry Canada - DeWalt DS100 Instruction Manual

Industry Canada

• NOTICE: this equipment meets the applicable Industry Canada Terminal Equipment
Technical Specifications. This is confirmed by the registration number. The abbrevia-
tion, IC, before the registration number signifies that registration was performed based
on a Declaration of Conformity indicating that Industry Canada technical specifications
were met. It does not imply that Industry Canada approved the equipment.
• This certification means that the equipment meets certain telecommunications network
protective, operational and safety requirements as prescribed in the appropriate
Terminal Equipment Technical Requirements documents. The Department does not
guarantee the equipment will operate to the user's satisfaction.
• The RINGER EQUIVALENCE NUMBER (REN) for this terminal equipment is noted on
the Base Unit label. The REN assigned to each terminal equipment provides an indi-
cation of the maximum number of terminals allowed to be connected to a telephone
interface. The termination on an interface may consist of any combination of devices
subject only to the requirement that the sum of the Ringer Equivalence. Numbers of all
the devices does not exceed five (5.0).
• Before installing this equipment, users should ensure that it is permissible to be con-
nected to the facilities of the local telecommunications company. The equipment must
be installed using an acceptable method of connection.
• The customer should be aware that compliance with the above conditions may not pre-
vent the degradation of service in some situations.
• Repairs to certified equipment should be coordinated by a representative designated
by the supplier. Any repairs or alterations made by the user to this equipment or equip-
ment malfunctions may give the telecommunications company cause to request the
user to disconnect the equipment.
• Users should ensure for their own protection that the electrical ground connections of
the power utility, telephone lines and internal metallic water pipe system, if present, are
connected together. This precaution may be particularly important in rural areas.
• CAUTION: Users should not attempt to make such connections themselves, but should
contact the appropriate electric inspection authority, or electrician, as appropriate.
• The Load Number (LN) assigned to each terminal device denotes the percentage of
the total load to be connected to a telephone loop which is used by the device, to pre-
vent overloading. The termination on a loop may consist of any combination of devices
subject only to the requirement that the total of the LNs of all the devices does not
exceed 100.
IC: 2309A-ECNCA (Base Unit) and
IC: 2309A-ETRT2M (Key Chain Remote)
Warnings
For your convenience and safety, the following warning labels are on the Base Unit and
Key Chain Remote:
DS100 BASE UNIT
• To reduce the risk of injury, user must read and understand Instruction Manual.
• Use only with D WALT authorized power sources designated for this product.
E
• Not for personal protection.
• Contains Lead-Acid battery. Must be recycled or disposed of properly. See Instruction
Manual.
DS200 KEY CHAIN REMOTE
• To reduce the risk of injury, user must read and understand Instruction Manual.
FREE WARNING LABEL REPLACEMENT: If your warning labels become illegible or are
missing, call 1-800-4-D WALT for a free replacement.
E
v