Connection Of Master And Slave Mode; Warranty Regulation - HELIX Competition SPXL 1000 Manual

14 Phase control
This control enables the phase of the bass signal to be shifted by
180° in order to achieve optimum delay equalization with the
other channels.
15 Remote bass control connector
To control the bass level from the driver position.
16 Master and Slave Mode
The SPXL 1000 is a „real-mono" amplifier. In order to double the
power it can be connected to a second SPXL 1000 via the Master
and Slave Mode. In order to operate two amplifiers in this mode,
they must be connected with a RCA cable (In/Out). Amplifier1
(Master) takes over the complete control (active crossover, gain
etc.) and provides the +signal at the bridge out speaker connec-
tor (see No. 6 and figure page 7). Amplifier 2 (Slave) provides the
-signal at its bridge out speaker connector for the subwoofer (see
No. 6 and figure page 7).
Attention: Make sure that amplifier1 is switched on
master and amplifier 2 is switched on slave. In this mode
the minimum impedance is 2 ohms.
17 Power LED
Shows the operation mode of the amplifier.
18 Protection LED
The red LED indicates malfunctions of the amplifier.
The SPXL amplifier has several electronic protection circuits that
shut off the amplifier at overheating, overloading, short-circuit on
loudspeaker, low-ohmic mode or defective power supply.
Please check for connecting failures such as short-circuits, wrong
connections and over-temperature.
If the amplifier does not turn on it is defect and has to be send to
your local authorized dealer for repair service. A detailed descrip-
tion of the malfunction and the purchase receipt has to be atta-
ched.
CONNECTION OF MASTER AND SLAVE MODE SPXL 1000

WARRANTY REGULATION

Due to the high quality standard Helix products achieved an
excellent international reputation. Therefore we grant a warran-
ty period of 2 years.
The products checked and tested carefully during the entire pro-
duction process. In the case of service note the following:
1) The 2 years warranty period commences with the purchase
of the product and is applicable only to the original owner.
2) During the warranty period we will rectify any defects
due to faulty material or workmanship by replacing or repai
ring the defective part at our decision.
Further claims, and in particular those for price reduction,
cancellation of sale, compensation for damages or subse
quential damages, are excluded. The warranty period is not
altered by the fact that we have carried out warranty work.
3) Unauthorized tampering with the product will invalidate this
warranty.
4) Consult your authorized dealer first, if warranty service is
needed. Should it be necessary to return the product to the
factory, please insure that
a) the product is packed in original factory packing in
good condition
b) the product is shipped prepaid, i.e. at your expense
and risk
c) the receipt/invoice as proof of purchase is enclosed
5) Excluded from the warranty are:
a) Shipping damages, either readily apparent or concea-
led (claims for such damages must be immediately
notified to the forwarding agent).
b) Scratches in metal parts, front panels or covers etc.
This must be notified to your dealer within 5 days of purchase.
c) Defects caused by incorrect installation or connec-
tion, by operation errors, by overloading or by external force.
d) Products which have been repaired incorrectly or
modified or where the product has been opened by
other persons than us.
e) Consoquential damages to other equipments.
f) Reimbursement when repairing damages by third
parties without our previous permission.
7