Clear Cmos & Reset Password; Soft Power Connector - TYAN TRINITY 400 Manual

1-B. Panel Connector Settings (Jumper J16)
LED +
LED -
Ground
Reset
VCC
IRRX
Ground
IRTX
RESV
J16
2 4
1 3
1-C. Speaker Connector (Jumper J12)
The speaker should be connected to pins 1-4 of jumper J12. As default,
pins 3-4 of jumper J12 are connected to the internal buzzer.
1-D. Wake-On LAN (CON3)
1-E. Wake-On Ring (CON2)
1-F. Clear CMOS and Reset Password (Jumper JP2)
J P
If you have been locked out of your system because you forgot your password
or set the CMOS incorrectly, follow the instructions below.
! ! ! ! !
1. Power off the system, UNPLUG POWER CONNECTOR
impor-
2. Set jumper JP2 to pins 2 and 3
tant!
3. Wait for 2 seconds, then return jumper JP2 to pins 1 and 2.
4. Power on the system again.
By following this procedure, you will erase your password and reset the CMOS
to the BIOS defaults.
S1854 Trinity 400
1 2 LED Green
3 4 LED Yellow
5 6 Power On/Off
7 8 Ground
9 10 NC.
11 12 Power +5V
13 14 N.C
15 16 N.C
17 18 N.C
6 8 10 12 14
5 7 9 11 13
D e a f u t l R s e
2
1 2 - 2 3 -
To p
16 18
Bottom
15 17
t e
17
Power LED:
For 2-pin: bicolor/single
color - Use pins 2-4
For 3-pin: Use jumper D31.