Pioneer AVIC-Z110BT Operation Manual page 183

Flash memory multimedia av navigation receiver
Table of Contents

Advertisement

Appendix
Symptom
"Rear display" picture disap-
pears.
Nothing is displayed and the
touch panel keys cannot be
used.
There is no response when the
touch panel keys are touched, or
a different key responds.
The external storage device
(USB, SD) cannot be used.
Problems in the AV screen
Symptom
CD or DVD playback is not pos-
sible.
The screen is covered by a cau-
tion message and the video can-
not be shown.
No video output from connected
equipment.
No video output from connected
iPod.
The audio or video skips.
Cause
The source disc being listened to in
the navigation system has been
ejected.
There is a problem with the "Rear
display", for example a faulty wiring
connection.
An AV source that cannot output to
the rear display is selected.
The setting for the rear view camera
is incorrect.
The shift lever was placed in [R]
when the rear view camera was not
connected.
The touch panel keys deviate from
the actual positions that respond to
your touch for some reason.
The USB storage device has been
removed immediately after plugging
it.
Cause
The disc is inserted upside down.
The disc is dirty.
The disc is cracked or otherwise da-
maged.
The files on the disc are an irregular
file format.
The disc format cannot be played
back.
The loaded disc is a type this system
cannot play.
The parking brake lead is not con-
nected or applied.
The parking brake interlock is acti-
vated.
[AV1 Input] or [AV2 Input] setting
is incorrect.
The connection of the USB interface
cable for iPod is incorrect.
The navigation system is not firmly
secured.
Action (Reference)
Before ejecting the disc, switch the source.
This problem may occur when certain con-
nection methods are used.
Check the "Rear display" and its connection.
Select an appropriate AV source.
Select the appropriate setting for the rear
view camera.
Select the correct polarity setting for [Back
Camera]. (Page 101)
Perform touch panel calibration. (Page 102)
Park your vehicle in a safe place, and turn off
the engine. Turn the ignition key back to "Acc
off". Then start the engine again, and turn the
power to the navigation system back on.
Action (Reference)
Insert the disc with the label upward.
Clean the disc.
Insert a normal, round disc.
Check the file format.
Replace the disc.
Check what type of disc it is. (Page 196)
Connect the parking brake lead correctly, and
apply the parking brake.
Park your vehicle in a safe place and apply
the parking brake.
Correct the settings. (Page 162)
Connect both the USB plug and the RCA
cable side. (If only one of these connection
has been made, the iPod will not work prop-
erly.) (Page 33)
Secure the navigation system firmly.
Appendix
183
En

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents