Figure 8. Sff8087 To Sff8087 Connector Cable - Intel RES2SV240 Hardware User's Manual

Controller(or backplane) Connector Pin-
B10
B11
B12
B13
B14
B15
B16
B17
B18
To successfully connect the expander card to supported RAID devices and backplanes,
additional cables may be needed. They are not shipped with this expander card, but below
introduction provides detailed pin-out specification, so that users would be able to find
such cable from market.
In server chassis non-expander backplane that has SGPIO connector on it, following cable
is needed: SFF8087 to Four-port Internal Cable with one SGPIO Connector. Check the
RAID controller/module and server backplane configuration details from
http://www.intel.com/support/motherboards/server/
necessary cables are included and how to configure the cabling. Additional cables may be
needed depending on different types of initiator and target devices.
Intel® RAID Expander Card RES2SV240 Hardware User's Guide
Out
Pin No Signal
GND
SAS_A_SB_CTRL_TYPE
GND
SAS_TX_C_DP<2>
SAS_TX_C_DN<2>
GND
SAS_TX_C_DP<3>
SAS_TX_C_DN<3>
GND

Figure 8. SFF8087 to SFF8087 connector cable

Expander Connector Pin-Out
Pin No Signal
A10 SAS_A_SB4
A11 SAS_A_SB5
A12 GND
A13 SAS_RX_C_DP<2>
A14 SAS_RX_C_DN<2>
A15 GND
A16 SAS_RX_C_DP<3>
A17 SAS_RX_C_DN<3>
A18 GND
in order to get more details of whether
17