Table of Contents
Advertisement
2.14 – Installing the Memory
Before attempting to install any type of memory, make sure that the memory you have is
compatible with the motherboard as well as the processor. For example, while PC1600 DDR
SDRAM modules are compatible wi t h all DDR based motherboards, they will not work if you are
required to run the motherboard and proc essor at 133MHz (DDR 266MHz). For this, PC2100 DDR
modules are required. Critically important is whether you're using the recommended memory for
the current board you have. For this information, please check TYAN's website at:
The following diagram shows the types of RAM modules you may encounter depending on your
board:
Here are a few key points to note before installing memory into your Tiger MPX:
At least ONE DDR SDRAM module must be installed for the system to turn on and
POST (power on self test).
128MB, 256MB, and 512MB, 1GB PC2100/PC1600 DDR SDRAM memory modules are
supported.
All installed memory will be automatically detected so there is no need to set any
jumpers or settings.
The Tiger MPX supports up to 4GB* of memory.
*The AMD-760 MPX requires a portion of memory to be reserved for PCI devices. Allocation for these devices is dependent on the
number of PCI devices installed, and option ROM for each device. Common configurations will see 3.5GB to 3.8GB of available
memory.
12
http://www.tyan.com
www.tyan.com
Advertisement
Table of Contents
