Connecting A Cd Player; Connecting An Antenna - Marantz NR1402 Owner's Manual

Connecting a CD player

• You can enjoy CD sound.
• Select the connector to use and connect the device.
Cables used for connections
Audio cable (sold separately)
L
Audio cable
R
Optical cable
CD player
AUDIO
OPTICAL
AUDIO
OUT
OUT
L R
L R
L R
in Set as Necessary
Set this to change the digital input connector to which the input
source is assigned.
"Input Assign" (vpage 64)

Connecting an antenna

• Connect the FM antenna or AM loop antenna supplied with the unit
to enjoy listening to radio broadcasts.
• After connecting the antenna and receiving a broadcast signal
(vpage 20 "Listening to FM/AM broadcasts"), fix the antenna
with tape in a position where the noise level becomes minimal.
L
R
AM loop antenna
(supplied)
q w
Black
White
AM outdoor
antenna
n AM loop antenna assembly
1
Direction of broadcasting station
2
FM outdoor
antenna
75 Ω coaxial
e
cable
n Using the AM loop antenna
Suspending on a wall
Suspend directly on a wall without assembling.
FM indoor
antenna
Standing alone
(supplied)
Use the procedure shown above to assemble.
• Do not connect two FM antennas simultaneously.
Ground • Even if an external AM antenna is used, do not disconnect the AM
• Make sure the AM loop antenna lead terminals do not touch metal
• If the signal has noise interference, connect the ground terminal
• If you are unable to receive a good broadcast signal, we recommend
9
Put the stand section
through the bottom of the
loop antenna from the
rear and bend it forward.
Loop
antenna
Insert the projecting part
into the square hole in
the stand.
NOTE
loop antenna.
parts of the panel.
(GND) to reduce noise.
installing an outdoor antenna. For details, inquire at the retail store
where you purchased the unit.
Stand
Square
hole
Projecting
part
Nail, tack, etc.