Recalling And Saving Scenes; Scene Recall - Yamaha LS9 Quick Start Manual

Recalling and Saving Scenes

The LS9 allows you to save mix settings, input and output port patch settings, and other settings as "scenes" with original
names for easy identification. The available scene number range is 000 ~ 300. Scene number 000 is pre-programmed with
the console's default settings and is read-only� Scene numbers 001 ~ 300 can be written to and read from as required� Scene
data is stored in a special buffer memory that will retain the settings even is there is an unexpected shutdown due to power
trouble�
● Scene Recall
Let's begin by recalling the console's default settings (reset the console)� To recall scene 000 either use the INC/DEC keys or
the dial to display "000" in the SCENE field, then press the [ENTER] key. A confirmation message will appear, and scene 000
will actually be recalled when you press the [ENTER] key a second time� By recalling scene 000 you "reset" or "normalize" the
entire console in one quick operation�
Note:By assigning scene 000 to one of the USER DEFINED KEYS (to be described later), you can recall it and therefore rest the console by pressing a single key.
Once the console has been reset you can begin to edit the various
parameters for your mix� But of course you can edit parameters from
any scene number� When any changes have been made to the currently
selected scene an ("Edit") will appear below the scene title� This makes it
E
easy to tell whether the scene has been edited or not�
● Scene Save
When the required settings have been made, save the scene�
Press the SCENE MEMORY
key in the DISPLAY ACCESS
section as many times as
necessary until the SCENE
LIST display appears.
Make sure that the cursor is outside the display area and use the dial or IN/DEC keys to select the scene number you want to
store your new scene to� When you've selected a scene position the cursor at the [STORE] button and press the ENTER key�
The SCENE STORE pop-up window via which you can enter a scene name will appear�
10
Scene number Scene title
Scene 000 is read-only. When any parameter in
the selected scene has been edited a yellow
appear.
Position the cursor at the [STORE] button in the SCENE STORE
pop-up window and press the [ENTER] key. A confirmation
message will appear. Position the cursor at the [OK] button and
press the ENTER key to save the current settings to the selected
scene. The new scene number will appear in the scene number
field on the display, and the edit indicator will disappear.
E
will
E