Caliper Suspension Sealing - BENDIX SB-6-SB-7 AIR DISC BRAKE Manual

8 Caliper Suspension sealing

(Replacement of inner Boot (9) )
(for the Axial and Radial Disc Brake)
Remove Caliper (see Section 10.1)
Remove Ring (58)
Pull out Sleeve (5)
Push out Boot (9) with screw driver.
Inspect and clean contact area of Boot (9)
Put new Boot (9) into the Cup (arrow) of the Tool C
(Order No II19253).
Position Sleeve with Boot (9) into the Caliper bore
and pull in.
Fit the Sleeve (5)
The Boot end must engage in the groove of the
Sleeve (5) (arrow). Lock with Ring (58) by pushing
on until it engages.
Important:
Before fitting the Caliper, the unsealed Sleeve with the
Rubber Bushing should be checked for its ability to
slide.
Fit Caliper (see Section 10.2).
5
9
9
58
5
58
9
M+P-KN-025
C
M+P-KN-026
9
VF 00127/15
27