Differential,
Final
Drive
DISMANTLING
AND
ASSEMBLING
INSTRUCTIONS
Dismantling
3. Insert large differential gears with press
fit threaded discs through oval opening
in differential housing and align with
flanges.
1. Remove taper roller bearing with an
extracter and P 263.
Note
4. Place small differential gears between the
large differential gears and turn until the
gear bores align with the bores in the
housing.
The claws of both arms must be machined.
5. Install taper roller bearing with P 264 b.
Assembling
1. Slide lockplate into groove of hex head
screws, pinch front part together with a
pliers to secure lockplate to hex head
screw and lock by pulling down over a
hexagon surface.
2. Coat semi -circular surfaces of differential
gears with MoS2 paste.
Dismantling and Assembling Differential
39-8
Printed in Germany