Advertisement
REMOVING
AND INSTAlliNG
CLUTCH
RELEASE
SPRING (FROM
1978 MODELS)
Removing
Checking
and
Lubricating
1. Loosen clutch cable at holder and detach
at release lever.
1. Check movement of release lever on
release lever shaft, correcting if not easy
enough.
2. Remove adjusting lever, by taking off the
circlip and, if applicable, disconnecting
spring for adjusting lever (since October,
1978).
2. Coat following
sliding and bearing
surfaces with a waterproof
lubricant,
for example: Staburags NBU 12/300
KB
from Kli.iber or a multi-purpose
grease.
-Release
lever bore.
-Release lever shaft (also splines for
adjusting lever).
-Release spring bearing surface on
console.
-Clutch
cable mounting point on release
lever.
nsta
ng
3. Press release lever forward with a suitable
tool (to disengage).
1. Slide release lever with spring on to lever
shaft and mount adjusting lever.
Note
Spring stretches when passing "top dead
center" and the release lever will snap
forward.
Printed in Germany -V.
1984
Removina and Installina Clutch Release Sorina
30-11
Advertisement
