Troubleshooting - Teac SR-LUXi Owner's Manual

Troubleshooting (1)

If you have a problem with your unit, read this page and try to solve the problem
yourself before calling your dealer or TEAC Service Center .
No power.
General
Display is dim.
No sound from
speakers.
Remote control
does not work.
The sound is noisy.
Power cannot be
turned off (put
in standby) when
using an iPod
touch/iPhone as
the sound source
Check the connection to the AC power supply . Check
whether or not the AC source is a switched outlet . If
it is, confirm that the switch is turned on .
Confirm that there is power to the AC outlet by
plugging another item such as a lamp or fan into it .
The power might not turn on if the backup battery
has died . Replace the battery or remove it from the
unit . A backup battery should last about 72 hours
(page 7) .
Press the DIMMER button to change the brightness .
When the unit is new, the brightness is set to the
lowest of three levels .
Select the source by pressing the FUNCTION button .
Adjust the volume .
Disconnect a headphones plug from the PHONES
jack if one is connected .
Press the Standby/On (
on .
If the battery is exhausted, replace it with a new one .
Use the remote control unit within the operating
range (16 ft/5 m), and point it at the front panel .
Remove obstacles between the remote control unit
and the main unit .
If a bright light is near the unit, turn it off .
The unit might be too close to a TV or similar device .
Relocate the unit farther away from such devices, or
turn them off .
When using an iPod touch or an iPhone with this
unit, if you use any application other than the iPod
applications, the SR-LUXi power might turn on again
soon after it is turned off (put in standby) . Since the
unit cannot turn the iPod touch/iPhone power off
when such an application is running, you must quit
such an application before turning the SR-LUXi off
(putting it in standby) .
Continued on the next page
) button to turn the unit
25