Troubleshooting - Teac DS-H01 Owner's Manual

Troubleshooting

If you experience a problem with the unit, please refer to the following troubleshooting advice
before seeking repair . If you still have a problem, contact the retailer where you purchased the unit
or TEAC customer service (on the back cover) .
The following explanations refer to an iPod, but they also apply to use with an iPhone or iPad .
No power
General
Power indicator
does not light
when power
button pushed
iPod not
recognized
iPod music cannot
be played back
The iPod does not
recharge
No video output
Noise appears on
TV screen
Since this unit uses a microcontroller, external noise and other interference can
cause the unit to malfunction . If this occurs, unplug the power cord, wait for a
while, then restore power to the unit and try using it again .
16
Check that the power cord is properly connected
to the power source . If the source is switched, make
sure that the switch is turned on .
Confirm that power is supplied to the outlet by
plugging in another electric device .
If nothing is connected to this unit when the power
is turned on, it will enter standby mode, and the ring
around the button will not light blue . When you
connect an iPod to the dock connector or connect
an operating computer to the unit using a USB
cable,the ring around the button (power indicator)
will light blue .
Confirm that the iPod model can be used with this
unit . (See page 9 . )
If you are using an iPod case, remove it so that the
iPod can dock securely .
If PC SYNC is set to ON, the iPod cannot be used for
playback .
Set the PC SYNC switch to OFF . (See page 15 . )
When connected to a computer that does not
support recharging of an iPod, the connected iPod
will not be recharged if the PC SYNC USB switch is
set to ON . In this case, set the PC SYNC USB switch to
OFF to recharge the connected device .
Press the VIDEO button on the remote control . (See
page 14 . )
If the iPod has a TV Out menu item, set it to On or
Ask .
Check that the iPod TV signal setting is NTSC or PAL
as appropriate . (See page 14 . )