Desa TC36N Series Owner's Operation And Installation Manual page 25

Desa owner's operation and installation manual direct-vent fireplace tc36n,tc36p
Table of Contents

Advertisement

FIREPLACE
INSTALLATION
Continued
Installing 9-Volt Alkaline Battery in Hand-
Held Remote Control Unit
1. Remove battery cover on back of remote
control unit.
2. Attach terminal wires to a 9-volt alkaline
battery (not included). Place battery into the
battery housing.
3. Replace battery cover onto remote control
unit.
Remote Control Unit
Battery Cover
Terminal
Wires
9-Volt
Battery
Figure 39 - Installing Battery in Hand-
Held Remote Control Unit
REMOVING/REPLACING GLASS
DOOR
CAUTION: Do not operate
this fireplace with a broken glass
door panel or without the glass
door panel securely in place.
For replacement part informa-
tion see Replacement Parts,
page 37.
CAUTION: Wear gloves and
safety glasses while handling
or removing broken glass. Do
not remove if glass is hot. Keep
children and pets away from
glass.
WARNING: If fireplace has
been running, turn off and un-
plug fireplace. Let cool before re-
moving glass door or louvers.
116192-01E
Removing Louver Panels
Remove the top and bottom louver panels by si-
multaneously pulling both top end spring latches
towards the center of the appliance until they are
disengaged from the locating holes (see Figure 40).
Repeat for bottom spring latches and pull the lou-
vers outward. To install or replace items removed,
simply reverse the procedures above.
Louver
Panel
Figure 40 - Removing Louver Panel
Removing Glass Door
If replacement of glass is necessary, the entire
assembly, glass and frame, must be replaced. If
glass is broken, wear gloves and tape the remaining
Battery
fragments onto the frame.
Housing
1. Remove screen assembly by pushing the rod
either left or right and then down and forward
to remove screen/rod assembly from the fire-
box. Set assembly aside.
2. Lift up on latches to unlock. There are two on
top of firebox and two below firebox that hold
glass door in place (see Figure 41).
3. While holding glass door to prevent it from
falling and causing injury, remove the five
screws from the hinge located on the left side
of door frame assembly (see Figure 41).
Unlock
Latch
Screw
Hinge
Glass Frame
Assembly
Figure 41 - Removing/Replacing Glass
www.desatech.com
Lock
Door
Spring
Latch
25

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tc36p seriesVtc36n seriesVtc36p series

Table of Contents