Desa TC36N Series Owner's Operation And Installation Manual page 24

FIREPLACE
INSTALLATION
Continued
PRESSURE TESTING FIREPLACE GAS
CONNECTIONS
1. Open equipment shutoff valve (see Figure 33,
page 23).
2. Open propane/LP supply tank valve for
propane/LP fireplace or main gas valve
located on or near gas meter for natural gas
fireplace.
3. Make sure control knob of fireplace is in the
OFF position.
4. Check all joints from equipment shutoff valve
to gas valve (see Figure 34, page 23, for
propane/LP or Figure 35, page 23, for natural
gas). Apply noncorrosive leak detection fluid
to all joints. Bubbles forming show a leak.
Correct all leaks at once.
5. Light fireplace (see Operating Fireplace, page
27). Check all other internal joints for leaks.
6. Turn off fireplace (see To Turn Off Gas to Ap-
pliance, page 28).
INSTALLING OPTIONAL WALL
MOUNT SWITCH - GWMS2
1. Connect one terminal of 25 ft. wire for the wall
switch to the TPTH terminal on the valve. Con-
nect remaining wire terminal to the TH terminal
on the valve. Make sure that the wire terminals
are in the positions on the unit as pictured in
Figure 36. If wires are not connected as shown
the switch will not work.
2. Route the 25 ft. wire through openings pro-
vided on the sides of the burner system to a
convenient location to mount your switch.
3. Connect one bare wire end to each of the
terminals of the GWMS2 wall switch.
4. Install teh wall switch and cover in the wall.
Figure 36 - Connecting Wall Switch to
Control Valve
24
INSTALLING OPTIONAL WIRELESS
HAND-HELD REMOTE CONTROL
HRC100 AND HRC200 SERIES
Installing Remote Receiver
1. Open bottom louver and locate the switch
2. Unscrew the switch bracket. Lean bracket
3. Locate the battery clip mounted on the back of
4. Attach the terminal wires to the battery.
5. Connect wires from receiver to TH and TPTH
6. Replace the switch bracket.
9-Volt
Alkaline
Battery
Figure 37 - Attaching Alkaline Battery to
To Optional
Remote
Accessory
To Wall Switch
Accessory
www.desatech.com
NOTICE: Use only alkaline bat-
teries (not included).
bracket on the right.
forward so you are able to access the back of
the remote receiver.
the receiver. Slide a 9-volt alkaline battery (not
included) through the clip (see Figure 37).
to control valve (see Figure 38).
Receiver
Battery Clip
Receiver
To Wall
Thermostat
Figure 38 - Control Valve Terminals
Terminal
Wires
116192-01E