Desa LMFP33NR(A) Owner's Operation And Installation Manual page 18

INSTALLATION
Continued
Left Top Log (#4)
Figure 28 - Installing Top Logs
Models LMFP33PRA and LMFP33NRA
1. Place the base of the middle log (#1) in the
U-shaped slots of the grate base. The cutout
on the right of the middle log should fit over
the burner (see Figure 29). Make sure the front
of the middle log is resting on the tabs of the
grate base and the cutout area is centered over
the burner "U" bend.
2. Locate pegs on the bottom of back log (#2).
Slide these pegs into the holes in the grate base
behind the burner (see Figure 30).
3. Locate the notches in the bottom of the front
log (#3). Place the front log on the grate fin-
gers. Make sure the notches of the front log
line up with the grate fingers (see Figure 31).
4. Place crossover log (#4) onto the pin (right) on
back log (#2) and into the recess of the middle
log (#1) (see Figure 32).
Tab
Burner
18
Right Top
Log (#4)
Middle
Log (#1)
"U" Bend
U-Shaped
Slot
www.desatech.com 111604-01H