Dell Precision 400 User Manual page 120

Message
The ICU detects
a resource conflict
between this card and
conflicting_card . The
conflicting resource
was: resource .
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary.
C-4 Dell Workstation Midsize Systems User's Guide
Table C-1. Configuration Utility Messages (continued)
Probable Cause
You added or modified a
card that now requires
a resource value
already in use by
conflicting_card .
Corrective Action
Try each of the following options until the prob-
lem is resolved:
•
Modify the card you are adding so that it uses
a different value for resource. See "Modify-
ing a Card" in Chapter 4 for instructions.
•
Modify conflicting_card so that it uses
a different value for resource. See "Modify-
ing a Card" in Chapter 4 for instructions.
•
If conflicting_card is not the system
board or riser board, remove it from the com-
puter. See "Removing a Card" in Chapter 4
for instructions.
•
Remove all expansion cards from the ICU,
and then add them back one at a time, begin-
ning with the new card and resolving
resource conflicts as they arise. See "Remov-
ing a Card" and "Adding a Listed Card" or
"Adding an Unlisted Card" in Chapter 4 for
instructions.
•
If you cannot resolve the resource conflict by
any of the preceding methods, remove the
new card. If you were modifying an existing
card, reset the modified card to its previous
resource value.