Table of Contents
Advertisement
945GC-M4 BIOS Manual
Onboard Floppy Controller
Select enabled if your system has a floppy disk controller (FDC) installed on the
system board and you wish to use it. If you installed another FDC or the system uses
no floppy drive, select disabled in this field.
Options:
Enabled (Default) / Disabled
Serial Port1 Address
Select an address and corresponding interrupt fo r the first and second seri al ports.
Options:
3F8/IRQ4 (Default) / 2F8/IRQ3 / 3E8/IRQ4 / 2E8/IRQ3 /Disabled
Parallel Port Address
T his item allows you to determine access onboard p arallel port controller with which
I/O Address.
Options:
378 (Default) / 278 / 3BC / Disabled
Parallel Port Mode
T his item allows you to determine how the parallel port should function.
Options:
Normal (Default)
EPP
ECP
ECP+EPP
ECP Mode DMA Channel
T his item allows you to select parallel port ECP DMA.
Options:
DMA3 (Default) / DMA0 / DMA1
Parallel Port IRQ
T his item allows you to select the IRQ for the onboard parallel port.
Options:
IRQ7 (Default) / IRQ5 / Disabled
Keyboard Pow erOn
T his item allows you to control the keyboard power on function.
Options:
Disabled (Default) / Specific Key / Stroke Key
Specific Key Enter
T his item will show only when Keyboard PowerOn is set "Specific Key."
Using Parallel port as Standard Printer Port.
Using Parallel Port as Enhanced Parallel Port.
Using Parallel port as Extended Capabilities Port.
Using Parallel port as ECP & EPP mode.
9
Advertisement
Table of Contents
