Wall Switch Installation - Desa (V)T32EP-A SERIES, (V)T32EN-A SERIES Owner's Operation And Installation Manual

FIREplaCE
INSTallaTION
Continued
8. Pull ember material apart into pieces no larger
than a dime. Place these pieces loosely and
sparingly directly onto the exposed section of
the front burner and along the space between
the burner and grate prongs (see Figure 45).
This will create the glowing ember appearance
as the flame touches the ember material. Do
not block air slots by using too much ember
material in one area. It is not necessary to use
all of the ember material provided.
9. Close glass door, lock door latches, replace
screen and close louvers (see steps 5 and 7 of
Removing/Replacing Glass Door, page 20).
Figure 43 - Installing Log No. 4
Figure 44 - Installing Logs No. 5 and No. 6
Ember Material
Figure 45 - Placing Ember Material on
116647-01B
Burner
www.desatech.com

WALL SWITCH INSTALLATION

The installation of a wall switch allows you to ac-
tivate the gas control valve and turn the fireplace
on and off. The wall switch is to be connected to
the incoming 120 volt regular household wiring
that supplies the electricity to the fireplace.
OPTIONAL REMOTE CONTROL
INSTALLATION (Model WRC)
Note: If using optional wireless hand-held remote
control, the wall switch must be in the ON position
to be operational. The remote control then becomes
the switching mechanism for fireplace operation.
1. Open lower louver panel.
2. The WRC model receiver does not require a
battery. The receiver can be installed by first
plugging the short extension cord into the
fireplace receptacle. Then plug the receiver
unit into the extension cord. Finally plug the
ignition module plug into the receiver unit (see
Figure 46).
3. Activate the remote handset battery by
removing the insulating tab on the back of
the handset (see Figure 47). The battery is
included pre-installed.
4. Once the battery is activated the unit is ready
to use.
5. Close lower louver panel.
Fireplace
Receptacle
Extension Cord
Figure 46 - Installing the WRC Remote
Receiver
Battery Cover
1 Volt Battery
Back of
Handset
Figure 47 - Installing Battery into Back
of Handset
Remote
Control
Receiver
Ignition Module
Plug
Pull to Remove
Insulation Tab
5