Desa (V)T32EN-A Series, (V)T32EP-A Series Owner's Operation And Installation Manual page 9

VENTING INSTALLATION
INSTRUCTIONS
Continued
7.
Combustible Exterior Wall Only:
the vent pipe before connecting horizontal run to vent cap (see
Figure 12).
8. Carefully move fireplace, with vent assembly attached, toward
wall and insert vent pipe into horizontal termination. The pipe
overlap should be a minimum of 1
9.
Combustible Exterior Wall Only:
interior wall surface and attach with screws provided (see
Figure 12). See Figure 13 for horizontal termination details.
10. Place fireplace into position and shim with noncombustible
material if needed. Nail or screw side flanges to framing to
secure unit in place. IMPORTANT: Make sure fireplace is
level before securing. If fireplace is not level it will not work
properly.
Figure 10 - Installing Horizontal Vent Cap (Noncombustible
Exterior)
Apply Mastic
to All Four Sides
Figure 11 - Installing Siding Standoff (Combustible Exterior)
116647-01A
Slide the wall firestop over
/ " (see Figure 13).
1
4
Slide wall firestop against
Vent Cap
Wood Screw
Cut Siding Away
to Fit Standoff
Standoff
Wood Screw
Vent Cap
Screws
www.desatech.com
VENTING INSTALLATION INSTRUCTIONS
Installation Planning (Cont.)
Vent Cap
(Horizontal
Termination)
Figure 12 - Connecting Vent Cap with Horizontal Vent Pipe
Interior Wall
Surface
Wall
Firestop
Horizontal
Vent Pipe
Screw
9 9