ACRONIS Backup & Recovery 10 Advanced Server SBS Edition User Manual page 96

2. In the E-mail addresses field, type the e-mail address to which notifications will be sent. You can
enter several addresses separated by semicolons.
3. Under Send notifications, select the appropriate check boxes as follows:

When backup completes successfully – to send a notification when the backup task has
completed successfully

When backup fails – to send a notification when the backup task has failed
The When user interaction is required check box is always selected.
4. For the e-mail message to include the log entries related to the backup, select the Add full log to
the notification check box.
5. Click Additional e-mail parameters, to configure additional e-mail parameters as follows, then
click OK:

From - type the e-mail address of the user from whom the message will be sent. If you leave
this field empty, messages will be constructed as if they are from the destination address.

Use encryption – you can opt for encrypted connection to the mail server. SSL and TLS
encryption types are available for selection.

Some Internet service providers require authentication on the incoming mail server before
being allowed to send something. If this is your case, select the Log on to incoming mail
server check box to enable a POP server and to set up its settings:

Incoming mail server (POP) – enter the name of the POP server.

Port – set the port of the POP server. By default, the port is set to 110.

User name – enter the user name

Password – enter the password.

Select the Use the specified outgoing mail server check box to enable an SMTP server and to
set up its settings:

Outgoing mail server (SMTP) – enter the name of the SMTP server.

Port – set the port of the SMTP server. By default, the port is set to 25.

User name – enter the user name.

Password – enter the password.
6. Click Send test e-mail message to check if the settings are correct.
Messenger service (WinPopup)
This option is effective for Windows and Linux operating systems on the sending machine and only
for Windows on the receiving machine.
This option is not available when operating under bootable media.
The option enables you to receive WinPopup notifications about the backup task's successful
completion, failure or need for interaction.
The preset is: Disabled.
Before configuring WinPopup notifications, make sure the Messenger service is started on both the
machine executing the task and the machine that will receive messages.
The Messenger service is not started by default in the Microsoft Windows Server 2003 family.
Change the service Startup mode to Automatic and start the service.
To configure WinPopup notifications:
1. Select the Send WinPopup notifications check box.
96 Copyright © Acronis, Inc., 2000-2010