Recovering The Storage Node - ACRONIS Backup & Recovery 10 Advanced Server SBS Edition User Manual

Note: This procedure requires restarting the machine. Use standard precautions when modifying the
registry.
1. In Registry Editor, open the following registry subkey:
HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Control\Session Manager\Memory
Management
2. Add the PoolUsageMaximum entry to the subkey:

Entry type: DWORD Value

Base: Decimal

Value: 40
3. Add the PagedPoolSize entry to the subkey:

Entry type: DWORD Value

Base: Hexadecimal

Value: FFFFFFFF
4. Quit Registry Editor, and then restart the machine.
If this does not resolve the problem, or for more details on adding these registry settings, see the
corresponding Microsoft Help and Support article.
Tip: In general, if a volume contains many files, consider using a disk-level backup instead of a file-level one. In
this case, you will be able to recover the entire volume as well as particular files stored on it.

6.3.13 Recovering the storage node

In addition to backing up data to centralized vaults managed by Acronis Backup & Recovery 10
Storage Node, you may want to perform a disk backup of the machine where the storage node itself
is installed.
This section describes how to recover the storage node registered on the management server in case
the storage node and the management server are installed on different machines (if they are
installed on the same machine, simply recover that machine).
Consider the following scenario:

You have a machine with the management server and a machine with the storage node.
 The storage node is registered on the management server.
 You backed up the machine with the storage node earlier, and have just recovered it—either on
the same machine or on a different machine.
Before using the recovered storage node, follow these steps:

If you have recovered the storage node on the same machine and no centralized vaults managed
by the storage node have been added or removed between the backup and recovery, do nothing.

Otherwise, do the following:
1. Connect to the management server and remove the storage node from it.
Note: All vaults managed by the storage node will also be removed from the management server. No
archives will be lost.
2. Add the storage node to the management server again, by specifiying the machine on which
the recovered storage node is installed.
3. Re-create the necessary managed vaults.
218 Copyright © Acronis, Inc., 2000-2010