Command-Line Parameters - ACRONIS Backup & Recovery 10 Advanced Server Installation Manual

To install Acronis Backup & Recovery 10 Management Console or Acronis Backup & Recovery
10 Upgrade Tool
1. Run the installation file:
For Acronis Backup & Recovery 10 Management Console:
o
AcronisManagementConsoleLinux.i686
For Acronis Backup & Recovery 10 Upgrade Tool: AcronisUpgradeTool.i686
o
2. Follow the on-screen instructions.
2.6.2.

Command-line parameters

By using command-line parameters, you can choose between the interactive and unattended
installation modes.
When running any of the installation files:
•
AcronisAgentLinux.i686 (Acronis Backup & Recovery 10 Agent for Linux)
•
AcronisBootableComponentsMediaBuilderLinux.i686 (Acronis Backup & Recovery 10 Bootable
Components and Media Builder)
•
AcronisManagementConsoleLinux.i686 (Acronis Backup & Recovery 10 Management Console)
•
AcronisDeduplication.i686 (Acronis Backup & Recovery 10 Deduplication)
•
AcronisUpgradeTool.i686 (Acronis Backup & Recovery 10 Upgrade Tool)
you can specify one or more of command-line parameters.
Examples
Example 1: Ubuntu system. The following command installs Acronis Backup & Recovery 10 Agent for
Linux on an Ubuntu system, which does not use RPM Package Manager:
./AcronisAgentLinux.i686 -c
Example 2: Unattended setup with license key. The following command installs Acronis Backup &
Recovery 10 Agent for Linux in the unattended mode (without asking for confirmations) and uses the
license key 12345-67890-ABCDE:
./AcronisAgentLinux.i686 -a -i BackupAndRecoveryAgent -l 12345-67890-ABCDE
Example 3: Registration on the management server. The following command:
•
Installs Acronis Backup & Recovery 10 Agent for Linux in the unattended mode.
•
Uses Acronis License Server located on the machine licensesrv, and a license key for the Acronis
Backup & Recovery 10 Advanced Server edition.
•
Registers the machine on Acronis Backup & Recovery 10 Management Server located on the
machine managementsrv once the installation is complete.
./AcronisAgentLinux.i686 -a -i BackupAndRecoveryAgent -L licensesrv -P AS -C
managementsrv -g srvadmin -w PassWd123
Parameters
Unless stated otherwise, the parameters are present in all installation files.
Copyright © Acronis, Inc., 2000-2009 27