INSTALLATION
Continued
INSTALLING 9-VOLT BATTERIES
Two 9-volt batteries (not included) are required
to operate this heater with the wireless hand
held remote control set. Install one battery in the
receiver and one in the hand-held remote control
unit. Note: Only use alkaline batteries.
Installing 9-Volt Battery in Receiver
1. Locate back of receiver under front burner of
heater.
2. Locate the battery clip mounted on the back
of the receiver.
3. Slide a 9-volt battery through the clip.
4. Attach the terminal wires to the battery.
Remote
Receiver
9-Volt Battery
Figure 36 - Installing Battery in Remote
Receiver
Figure 37 - Installing Battery in Hand-
Held Remote Control Unit
113109-01B
Battery Clip
www.desatech.com
19