18
OPTIONAL WIRELESS HAND-HELD
REMOTE CONTROL ACCESSORIES
(GHRCB and GHRCTB)
Installing Remote Receiver Unit
1. Disconnect switch wires from the control
valve.
2. Remove screws attaching switchplate.
3. Remove switch plate (see Figure 33). Discard
after removing.
4. Install remote receiver unit onto gas log heater
base using mounting clips.
5. Push clips firmly into place (see Figure 34).
6. Connect wires as shown in Figure 35.
Remote
Switch
Bracket
Screw
Switch Plate
Figure 33 - Switch Plate and Wiring
Mounting
Clips
Figure 34 - Installing Remote Receiver
White Wire
From Receiver
www.desatech.com
Harness
Remote Receiver
Red Wire From
Receiver
Figure 35 - Connecting Wires
Ignitor
Wires
Valve
113109-01B