Dell PowerVault MD3260i Troubleshooting Manual page 18

existing management view in MD Storage Manager.
Perform these steps:
1. Obtain the IP address of the RAID controller
you are adding. If the IP address is unknown,
see Using a Serial Cable to Configure Your
Management Port.
2. Start MD Storage Manager and select the MD
storage array containing the RAID controller.
3. From the Setup tab in the Array
Management Window, select Add Storage
Arrays.
4. In the Select Addition Method, select
Manual.
5. In the Add New Storage Array window,
select Out-of-Band management and enter
the IP address of the RAID controller.
6. Click Add.
If you are adding a single RAID controller
module or a new path to a management
port, a confirmation message appears.
7. Select Yes.
The new path and the existing path are
automatically merged.